#Ping console code

The packet is sent directly to the interface without taking the routing table into tag used to send the packet.Д®ntering stop or pressing the RETURN button terminates the ping command. Name of the interface used to send the packet when link-local addresses are used as the of the interface used to send the packet when link-local addresses are used as the destination, with additional specification of the routing tag.

Pings the global IPv6 address '2001:db8::1'.ДЄddress or host name of the target computer Pings the link-local address 'fe80::1', which is accessible via the interface and/or the network 'INTRANET'. A percent sign (%) separates the name of the interface from the IPv6 address. This is the only way that the ping command knows which interface it should send the packet to. ДЇor IPv6, the scope of parameters is of central importance: IPv6 requires a link-local address (fe80::/10) to be assigned to every network interface (logical or physical) on which the IPv6 protocol is enabled, so you must specify the scope when pinging a link-local address. Performs a ping command to the link-local address via the interface specified by. Note: It is not possible to use this CLI option in combination with the specification of a scope or an interface binding in the destination. If an invalid policy is specified, no pings are sent Possible values are traffic, bandwidth, round robin and all defined Dynamic Path Selection policies. If the ping target is reached via a load balancer, the policy makes a load-balancer decision when the pings are sent. Uses a named network, interface, or loopback address as the sender address Sets the ping's sender address (default: IP address of the device.

#Ping console code

DSCP (Differentiated Services Code Point) is used for QoS (Quality of Service). 65500).ДЄtomic fragments: (n)ever, (f)orce, (a)utomatic Ping to check internet connection Select the device in Remote Manager and click Actions > Open Console, or log into the IX14 local command line.

The path taken by the data packets to the target computer is displayed with all intermediate stations.Дo not stop pinging after receiving a PacketTooBig (DF), in order to achieve 'Path MTU Discovery'. Ping command returns no output to the CLI (quiet).

Immediately sends another request after a response. Returns the computer name of a specified IP address. Important: It is easy for flood ping to be misinterpreted as a denial-of-service (DoS) attack.